Code Soft MD2 Series Manuel d'utilisateur télécharger pdf (Page 56)

Assembling the stand

1. See the figure above, tighten the screws.

2. Bend the neck to the desired position for scanning.

3. Screw mounting: Screw one #10 wood screw into each screw-mount-hole until the base of the stand

is secured.

4. Tape mounting: ①Peel the paper liner off one side of each piece of tape and place the sticky

surface over each of the three rectangular tape holders. ②Peel the paper liner off the exposed

sides of each piece of tape and press the stand on a flat surface until it is secure.

1 2 ... 51 52 53 54 55 56 57 58 59 60

Pas de commentaire

Code Soft MD2 Series Manuel d'utilisateur Page 56